REVISED TOWER CRANE RESCUE RULES PUBLISHED

HSE endorsed CPA guidance on planned rescue now online

The Construction Plant-hire Association (CPA) has published Tower Crane Technical Information Note TIN 013: Rescue of Personnel From Height on Tower Cranes providing guidance on planning of the rescue of persons from height on tower cranes.

Evacuation and rescue must be planned for where tower cranes are being erected, used, altered, maintained, inspected, thoroughly examined or dismantled. The document does not cover the rescue of non authorised persons such as trespassers

The CPA guide explains that arrangements for emergency and rescue should not rely on the fire brigade and that:

“the primary duty for ensuring that there are adequate resources for carrying out rescue from a height of persons on a tower crane rests with the organisation in control of the premises on which any tower crane is sited. In the case of a construction site this is the Principal Contractor as defined by the Construction (Design and Management) Regulations 2007 (CDM).

In practice, it is likely that arrangements for rescue during the erection, alteration and dismantling (see 3.1) will be planned and implemented by the tower crane supplier. The responsibility for planning and implementing rescue during use, maintenance and thorough examination (see 3.2) lies with the Principal Contractor, who may take advice from the tower crane supplier.”

This article was posted on 10th May 2013 in ALL LATEST NEWS, CRANES TOWER.
PP Construction Safety H&S Assistance and Consultancy service.

Construction Health & Safety News, Advice and Information from PP Construction Safety

REVISED TOWER CRANE RESCUE RULES PUBLISHED

HSE endorsed CPA guidance on planned rescue now online

Latest Construction Health and Safety News

FAILURE TO ISOLATE LEAVES WORKMAN PARALYSED

Conveyor guards removed before power source isolated

TRADING STANDARDS AND HSE ACT IN CONCERT

Director given prison term over fraud and health and safety breaches

BUILDER ERROR CAUSED RESIDENT FALL FROM BALCONY

Director prosecuted over refurb project danger to others

FORMER HSE BOSS CONDEMNS VALUE ENGINEERING

Resident and public safety must match workforce safety progress

RETAILER FINED AFTER FAN AMPUTATES FINGERS

Maintenance engineer injured during roof fan repair works

POOR PLANT ISOLATION CAUSED CONVEYOR DANGER

Arm of fitter trapped between conveyor drum and belt

BUILDING OWNER FAILED TO CHECK FOR ASBESTOS

Prison sentence for businessman after previous HSE enforcement

YOUNG WORKER LOSES FINGERS IN SAWING INCIDENT

Provision of training and information could not be proved

HSE ENFORCEMENT WEEKLY UPDATE 10th OCT 2018

Prosecutions and enforcement notices register latest version

MD PROSECUTED ALONGSIDE ERRANT COMPANY

Director held personally responsible for poor site conditions

ASBESTOS REMOVAL STARTED BEFORE R & D SURVEY

Asbestos insulation board found outside building being refurbished

INEFFECTIVELY BRAKED SAW CAUSED AMPUTATIONS

Retro-fitting of precautions may be required on older machines

FALL THROUGH FRAGILE CEILING TILES

Failure to implemented control measures for working near fragile surfaces

HSE SEEKS CONSTRUCTION ‘DUST BUSTER’ PARTNERS

Regulator uses social media to raise dust dangers and using right controls

MAJOR HOMES BUSINESS EXPOSED PUBLIC TO RISK

Residential property refurb project created carbon monoxide danger

HSE CONSTRUCTION DUST CONTROL ‘BLITZ’ STARTS

Regulator inspections will check health taken as seriously as safety

FLOOR CONSTRUCTION SYSTEM OF WORK UNSAFE

Welder fell 3m from mezzanine area through purlin openings

WORKER SUFFERS FATAL BURNS IN OXYGEN RICH AREA

Sparks from angle grinder ignited clothing of workman in confined space

RIBA PUBLISH DRAFT POST GRENFELL FIRE SAFETY PLAN

Architects institute consults on ‘golden thread of fire safety information’

MAJOR UK CONTRACTORS HIT BY MAJOR FINES

Firms ordered to pay over £3m after foot trapped in rotating ‘screw’

DRIVER DIED TRAPPED BETWEEN TRAILER AND VEHICLE

Firm fined £1.5 million over failure to assess coupling operations

ACTUAL SYSTEM OF WORK WAS OPPOSITE OF RAMS

Workman fell 4m through fragile asbestos roof sheet

CDM PRINCIPAL DESIGNER FUNCTION MISUNDERSTOOD?

Consultants claim CDM 2015 design risk management has ‘gone backwards’

RISK ASSESSED PRECAUTIONS NOT IMPLEMENTED

Action not paperwork essential to prevent fall during lifting operation

CROSSRAIL PUBLISH BEST PRACTICE H&S GUIDES

Sharing major project best practice can leave a lasting legacy

News Archives